SWEP Heat Exchanger Sizing Enquiry

Heat Exchanger Sizing Enquiry

Need a SWEP Heat Exchanger Sized?

Send us your system information and B.E.E. will help select the correct SWEP brazed plate heat exchanger for your application.

You don't need to know every value.
Complete as much as you can and leave anything you're unsure of blank. We'll help with the rest.

1 Application

2 System Details

3 Additional Details

4 Your Details

Tell Us About the Application

Start with the basics. We'll only ask for the information relevant to your enquiry.

Project / Site Reference Optional

What is the heat exchanger being used for? *

Please tell us what the heat exchanger is being used for *

Existing Heat Exchanger Make / Model If known

Do you know the exact model you require? *

Yes No

Required Heat Load (kW) If you don't know the required heat load, leave this blank. On the next step, complete the fluid type, temperatures and flow rate for at least one side and we'll calculate it.

System Details

Complete what you know. These details allow us to run the SWEP selection accurately.

Required because no heat load was entered Please complete the fluid type, inlet temperature, outlet temperature and flow rate for either the Primary or Secondary Side so we can calculate the required duty.

Primary Side

Usually the heat source circuit, e.g. boiler, heat pump or other heat source.

Heat source side

Primary Side Fluid Type

Glycol Concentration (%) If known

Please specify the fluid *

Primary Side Inlet Temperature (°C) Temperature entering the heat exchanger from the heat source.

Primary Side Outlet Temperature (°C) Temperature leaving the heat exchanger on the primary side.

Primary Side Flow Rate

If known. If no heat load was entered, a flow rate is required for whichever side you use for the duty calculation.

Maximum Allowable Pressure Drop – Primary Side (kPa) If known

Secondary Side

Usually the load circuit, e.g. heating system, cylinder/DHW circuit, thermal store or cold mains water.

Load side

Secondary Side Fluid Type

Glycol Concentration (%) If known

Please specify the fluid *

Secondary Side Inlet Temperature (°C) Temperature entering the heat exchanger on the secondary side.

Secondary Side Outlet Temperature (°C) Temperature leaving the heat exchanger on the secondary side. If unknown, enter the temperature you are aiming to achieve.

Secondary Side Flow Rate

If known. If no heat load was entered, a flow rate is required for whichever side you use for the duty calculation.

Maximum Allowable Pressure Drop – Secondary Side (kPa) If known

Please enter the required heat load, or complete the fluid type, inlet temperature, outlet temperature and flow rate for at least one side so we can calculate it.

Additional Details

Just a couple of final details before we take your contact information.

Preferred Connection Size / Type If known. We'll take this into account, but the most suitable heat exchanger may have a different connection size depending on the required duty and operating conditions.

Quantity Required

Additional Information / Notes Anything else that may help us with the selection.

Your Details

Let us know where to send your SWEP selection.

Name *

Company

Email *

Telephone Optional