Manuals

Need a SWEP Heat Exchanger Sized?

Send us your system information and B.E.E. will help select the correct SWEP brazed plate heat exchanger for your application.

You don't need to know every value.
Complete as much as you can and leave anything you're unsure of blank. We'll help with the rest.

Application

System Details

Additional Details

Your Details

Tell Us About the Application

Start with the basics. We'll only ask for the information relevant to your enquiry.

Project / Site Reference Optional

What is the heat exchanger being used for? *

Please tell us what the heat exchanger is being used for

Existing Heat Exchanger Make / Model If known

Do you know the exact model you require? *

Yes No

Required Heat Load (kW) If you don't know the required heat load, leave this blank. On the next step, enter the fluid types, temperatures and a flow rate for at least one side and we'll calculate it.

System Details

Complete what you know. These details allow us to run the SWEP selection accurately.

Primary Side

Usually the heat source circuit, e.g. boiler, heat pump or other heat source.

Primary Side Fluid Type

Glycol Concentration (%) If known

Please specify the fluid

Primary Side Inlet Temperature (°C) Temperature entering the heat exchanger from the heat source.

Primary Side Outlet Temperature (°C) Temperature leaving the heat exchanger on the primary side.

Primary Side Flow Rate

If known. If the required heat load is unknown, we'll need the flow rate for at least one side to calculate it.

Maximum Allowable Pressure Drop – Primary Side (kPa) If known

Secondary Side

Usually the load circuit, e.g. heating system, cylinder/DHW circuit, thermal store or cold mains water.

Secondary Side Fluid Type

Glycol Concentration (%) If known

Please specify the fluid

Secondary Side Inlet Temperature (°C) Temperature entering the heat exchanger on the secondary side.

Secondary Side Outlet Temperature (°C) Temperature leaving the heat exchanger on the secondary side. If unknown, enter the temperature you are aiming to achieve.

Secondary Side Flow Rate

If known

Maximum Allowable Pressure Drop – Secondary Side (kPa) If known

Additional Details

Just a couple of final details before we take your contact information.

Preferred Connection Size / Type If known. We'll take this into account, but the most suitable heat exchanger may have a different connection size depending on the required duty and operating conditions.

Quantity Required

Additional Information / Notes Anything else that may help us with the selection.

Your Details

Let us know where to send your SWEP selection.

Name *

Company

Email *

Telephone Optional